Main Content

Develop, Resize, and Calibrate Motors with Dynamometer Test Harness

The motor dynamometer reference application represents a motor plant and controller connected to an AC dynamometer. Using the reference application, you can design and test traction e-motors and controllers for your electrified powertrain vehicle. To create and open a working copy of the motor dynamometer reference application project, use this command.

By default, the reference application is configured with an 80 kW Flux-Based PMSM motor.

You can configure the reference application project for different dynamometer control modes. To implement the operating modes, the reference application uses variant subsystems.

This table summarizes the dynamometer tests.

TestObjectiveMethodMotor Variant
MappedDynamic PMSMFlux-Based PMSM

Resize Mapped Motor Model

Match motor torque to desired maximum power, torque, DC link voltage, and constant power speed ratio (CPSR).

Dynamometer resizes the mapped motor and motor calibration parameters.

For more details, see Resize Motors.

  

Resize Dynamic PMSM and Recalibrate Controller

Match motor torque to desired maximum power level and DC link voltage.

Dynamometer resizes the dynamic PMSM motor and motor calibration parameters. The dynamometer also recalibrates the controller.

For more details, see Resize Motors.

  

Resize Flux-based PMSM and Recalibrate Controller

Match motor torque to desired maximum power level and DC link voltage.

Dynamometer resizes the flux-based PMSM motor and motor calibration parameters. The dynamometer also recalibrates the controller.

For more details, see Resize Motors.

  

Run Performance Tests

Run dynamic and steady-state performance tests at different operating points of torque and speed.

Dynamometer controller commands a series of motor speeds and torques to the motor controller. At each quasi-steady-state operating point, the experiment records the motor plant model output and the controller commands for the current calibration parameters.

Motor System

The reference application includes variant subsystems for Mapped (steady-state), Dynamic PMSM, and Flux-Based PMSM motors.

ObjectiveMotor Variant

Simulate and validate motor system response based on high-level specifications.

Mapped

Simulate and validate linear dynamic models based on existing motor details.

Dynamic PMSM

Simulate and validate nonlinear dynamic models based on existing motor details.

Flux-Based PMSM

Performance Monitor

The reference application contains a Performance Monitor block that you can use to plot steady-state and dynamic results. You can plot:

  • Steady-state results as a function of one or two variables.

  • Dynamic results using the Simulation Data Inspector.

See Also

| | | |

Related Examples

More About