Clutch schedule for an eight-speed transmission
Simscape / Driveline / Transmissions
The 8-Speed block consists of four planetary gear sets and five clutches. The base shaft connects to the:
Planet gear carrier of the second planetary gear
Other gears through three clutches that determine the power flow path.
The follower shaft connects to the planet gear carrier of the first and fourth planetary gears. The other two clutches serve as brakes, grounding various gears of planetary sets two and three to the transmission housing.
This diagram shows an eight-speed transmission. The labels for the gear components are superimposed on the input and output gears. The table lists the gear and clutch components that are labeled in the diagram.
|P.G.1–P.G.4||Planetary gears, 1–4|
|C||Planet gear carrier|
|C–E||Forward clutches that control the power flow path|
|A–B||Forward, braking clutches|
Drive Ratios, Clutch Schedule, and Power Flow
The drive ratio between the transmission input and output shafts follows from the elementary gear ratios specified for the gear blocks. The elementary gear ratios are
NRx is the number of teeth in the planetary ring gear x, where x = 1, 2, 3, and 4.
NSx is the number of teeth in the planetary sun gear x, where x = 1, 2, 3, and 4.
The table shows the clutch schedule, drive-ratio expressions, drive-ratio default values, and the power-flow diagrams for each gear of the 8-Speed block. The schedule and gear ratios are based on the manufacturer data for the GM 8L90 eight-speed automatic transmission.
The letters in the clutch schedule columns denote the brakes and clutches. A value
1 denotes a locked state and a value of
an unlocked state. The clutch schedule generates these signals based on the Gear
port input signal. The signals are scaled through a Gain block and used as actuation
inputs in the clutch blocks.
The power-flow diagrams show the power flow paths between input and output shafts for each gear setting. Power flow is shown in orange. Connections to the transmission housing (a mechanical ground) are shown in black.
|Gear||Clutch Schedule||Drive Ratio Equation||Default Ratio||Power Flow|
Gear — Numerical input for the gear
Specify -1 for reverse, 0 for neutral, and 1–8 for the forward gears.
B — Base interface
Conserving port associated with the base shaft.
F — Follower interface
Conserving port associated with the follower shaft.
Initial gear — Gear state at the beginning of simulation
Neutral (default) |
Sets the initial engagement or disengagement of the clutches using the clutch schedule. When the transmission is in neutral, there is no power flow from the base shaft to the follower shaft.