Check size of junctions

Check ID: mathworks.jmaab_v6.jc_0907

Guideline: jc_0907: Size of junctions

Checks if the size of junctions is the same as the value set by the input parameter.

This check applies to the following target component:

This check requires a Simulink^® Check™ license.

This check does not include sub-checks because the JMAAB modeling guideline provides only one sub ID.

For reference, the guideline sub ID(s) that are recommended for use by the JMAAB modeling standards organizations are:

You can configure the following input parameter to customize the check action:

Input Parameter	Value	Default Value
Size of junctions	Size of junctions in a Stateflow chart	14

Condition	Recommended Action
Stateflow junctions are not set to the expected size.	Change the junction size to the value specified by the Size of junctions input parameter.

Runs on library models.
Analyzes content of library-linked blocks. By default, the input parameter Follow links is set to on.
Analyzes content in masked subsystems. By default, the input parameter Look under masks is set to all.
Allows exclusions of charts with all descendants.