Connect TFC Shield to the NXP FRDM-KL25Z Board
The NXP™ FRDM-TFC Shield can drive up to:
2 DC motors
2 servo motors
Read values from up to:
2 line scan cameras
2 momentary switches
1 four-position DIP switch
This shield should be used with the NXP FRDM-KL25Z board.
To connect the FRDM-TFC Shield to NXP FRDM-KL25Z board and to your PC:
Place the FRDM-TFC Shield firmly on the NXP FRDM-KL25Z board. The FRDM-TFC Shield stacked on the FRDM-KL25Z hardware is shown in the following figure.
Connect a USB cable from your computer to the OpenSDA mini-B USB connector of FRDM-KL25Z.