Diagnostics to improve link quality and performance.
Spectrum Analysis of Signals
Downstream spectrum analysis of signals using MATLAB®, Communications Toolbox™ and DSP System Toolbox™. You can either use captured signals, or receive signals in real time using the RTL-SDR Radio, ADALM-PLUTO Radio or USRP™ Radio. You can change the radio's center frequency to tune the radio to a band where a signal is present. You can then use the spectrum analyzer to view and make measurements on the received spectrum.
Spectrum Analysis of Signals in Simulink
Use Simulink® and Communications Toolbox™ to perform spectrum analysis of the downstream signals. You can tune the radio to a band where a signal is present by changing the center frequency. You can then use the spectrum analyzer to view and make measurements on the received spectrum. You can either use recorded data from a file, or receive over-the-air signals in real time using an RTL-SDR radio, ADALM-PLUTO radio, or USRP™ radio.
Frequency Correction for ADALM-PLUTO Radio in Simulink
Synchronize both the baseband sample rate and the center frequency of two PlutoSDRs by using the Frequency correction parameter of the ADALM-PLUTO Radio Receiver block.
Frequency Correction for ADALM-PLUTO Radio
Synchronize both the baseband sample rate and the center frequency of two PlutoSDRs by using the FrequencyCorrection property of comm.SDRRxPluto and comm.SDRTxPluto.
You clicked a link that corresponds to this MATLAB command:
Run the command by entering it in the MATLAB Command Window. Web browsers do not support MATLAB commands.
You can also select a web site from the following list:
How to Get Best Site Performance
Select the China site (in Chinese or English) for best site performance. Other MathWorks country sites are not optimized for visits from your location.