Configure properties of mixer for channel in ADC tile
rfDataConverter — RF data converter
RF data converter, specified as an
object. Via Ethernet, this object connects the host computer to the RF data converter on
the connected SoC device. Use the object functions and properties of this object to
configure the RF data converter.
tileId — Identifier of RF-ADC tile
Identifier of the RF-ADC tile connected to the programmable logic, specified
3. Available options for the RF-ADC tile ID vary
according to the specified RFSoC device. A tile contains several ADCs,
accessible as channels, and several shared timing units, including a clock
channelId — Channel identifier
Channel identifier for the selected ADC tile, specified as
options for the channel ID vary according to the specified RFSoC device.
mixerType — Type of mixer
Type of mixer used in the RF-ADC digital path, specified as
"Fine". When you specify
"Bypassed", no mixer is
included in the ADC digital path.
"Coarse" specifies the coarse
mixer, which enables mixing the data with a carrier at frequency ratios set by input
"Fine" specifies the fine
mixer, which enables the data to be shifted up or down in frequency by the
fineMixerScale input value.
mixerFrequency — Frequency for coarse or fine mixer
"-Fs/4" | scalar
When you specify
"Coarse" as the
the mixer frequency must be specified as one of these values:
"Fs/2"- Half of the sampling frequency
"Fs/4"- Quarter of the sampling frequency
When you specify
"Fine" as the
the mixer frequency must be a scalar. Units of the mixer frequency are in MHz.
eventSource — Source of update event for RF-ADC mixer
Source of the update event for the RF-ADC mixer, specified as
An event update can be made intermediately or can wait for another event within the
system. For detailed information on the event sources, see "Dynamic Update Events"
section in Zynq UltraScale+ RFSoC RF Data Converter v2.3.
NCOPhase — Phase value for output of NCO mixer
positive scalar value
Phase value for the output of the numerically-controlled oscillator (NCO) mixer,
specified as a positive scalar. The NCO phase applies only when you specify a fine mixer
by setting input
Introduced in R2020b