Hardware and Software Requirements

Required MathWorks Products

To use the I/O mode features of the Communications Toolbox™ Support Package for Xilinx® Zynq®-Based Radio, the following MathWorks® products are required:

  • MATLAB®

  • Communications Toolbox

  • Signal Processing Toolbox™

  • DSP System Toolbox™

To work with the hardware-software co-design workflow, the following MathWorks products are also required:

  • Simulink®

  • To target the FPGA fabric on the device: HDL Coder™ Support Package for Xilinx Zynq Platform (requires HDL Coder)

  • To target the ARM® processor on the device: Embedded Coder® Support Package for Xilinx Zynq Platform (requires Embedded Coder, Simulink Coder™, and the ARM Cortex®-A support package)

Required Third-Party Tools

  • Third-party tools required by the I/O mode features are automatically downloaded and installed during the support package installation.

  • To work with the hardware-software co-design and FPGA targeting workflows, you must manually install the following third-party tools:

    • Xilinx Vivado® development tools, version 2018.2

Hardware Support

 Xilinx Zynq-7000 All Programmable SoC ZC706 Evaluation Kit

 Xilinx Zynq UltraScale+ MPSoC ZCU102 Evaluation Kit

 Avnet ZedBoard

 ADI RF SOM

 PicoZed SDR (Before R2017b)

Related Topics