Info

This question is closed. Reopen it to edit or answer.

How can i involve four cpu on running a program in matlab 2014?

1 view (last 30 days)
when i use parpool or matlabpool,program uses only extra ram not cpu whatever i do,my program only uses 25% of cpu what should i do that its uses whole cpu or at least 75% of cpu?

Answers (1)

Chaitra
Chaitra on 26 Jun 2014
Edited: Chaitra on 26 Jun 2014
Executing parpool command starts a pool using the current cluster profile, with the pool size specified by your parallel preferences and the current profile. I would recommend you to check these parameter settings. If these parameter settings are absent, it defaults to the number of cores that your system has.
To start a cluster of 4 CPUs you can execute the command:
>>parpool 4
Execute this command and then run your program and check the usage of CPU. Also, you specified that there is 25% CPU utilization seen. Is this observed on all the CPUs on your system? The usage of CPU depends on how computationally intensive your program is.
  2 Comments
MA
MA on 26 Jun 2014
to your question,it uses 25% of whole 4 cpu or 100% of one cpu of my system
Chaitra
Chaitra on 27 Jun 2014
Is your program computationally intensive? Did you check the parameter settings?

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!