Yes, the speed of SRM (Switched Reluctance Motor) can be measured using hall or optical sensor with the help of “Hall Speed and Position” block. The “Hall Speed and Position” block provides functionality to interface with and process data from Hall or optical sensors commonly used in SRMs.
To utilize the “Hall Speed and Position” block for an SRM, you would need to connect the Hall or optical sensors to your hardware setup and acquire the sensor data. This may involve configuring the hardware interface, specifying the sensor channel, and setting the appropriate sampling rate.
The “Hall Speed and Position” block can assist in processing the sensor data and performing calculations specific to SRMs, such as determining the rotor position based on the sensor outputs.
It is important to note that the specific implementation details may vary depending on your hardware setup, sensor characteristics, and the requirements of your SRM application.
Please find below the documentation links to the relevant resources:
- Hall Speed and Position: https://www.mathworks.com/help/mcb/ref/hallspeedandposition.html
- Hall Validity: https://www.mathworks.com/help/mcb/ref/hallvalidity.html
- Speed Measurement: https://www.mathworks.com/help/mcb/ref/speedmeasurement.html
