MATLAB Answers

No deploy to hardware button in simulink (using the F2837xD with ccsv6)

14 views (last 30 days)
Yanis Benmohammed
Yanis Benmohammed on 4 Apr 2018
Answered: Gayatri Menon on 10 Apr 2018
Hi All, I'm interfacing the TMS320F28379D with MATLAB 2016a using the ccsV6. I have several problems and I'm unable to generate code and interact with the hardware board (ControlCARD). In the configuration parameters toolbar I haven't the line : Code Generation system target file : ert.tlc and the tab Code Generation is absent.
Also in the simulink windows the deploy to hardware button is missing. I think something is missing but I don't know what. The device is well connected and the target configuration is OK. Maybe the setup is imcomplete????

  0 Comments

Sign in to comment.

Answers (1)

Gayatri Menon
Gayatri Menon on 10 Apr 2018
Hi,
If you are using TI C2000 Support Package, it requires MATLAB Coder, Simulink Coder and Embedded Coder to work. Please refer the below link for more information:
Could you please check if you have the above-mentioned products installed in your system.You could check this by executing the following commands in MATLAB command Window
>> ver
Thanks

  0 Comments

Sign in to comment.

Sign in to answer this question.