Clear Filters
Clear Filters

using dc to dc boost converter multistage to boost 48v dc to 400v dc .

9 views (last 30 days)
Iam working on dc to dc boost converter 4-stage (marx topology boost converter) . the best result which i got to boost 48v is 75v . How can i boost 48v to 400v by this converter ?
The simulink module as follow

Answers (1)

Joel Van Sickel
Joel Van Sickel on 4 Jun 2024
There is nothing stopping you from using a boost converter to step up to a higher voltage, but you have to design it properly to be able to support 400V at the load that you provide. You active front end to the boost converter is also going to effect behavior. You should start by creating a single boost converter than works from 48V to 400V at the power level you will need for the full circuit. Then you can add the active front end and additional boost converters.

Communities

More Answers in the  Power Electronics Control

Categories

Find more on Electrical Block Libraries in Help Center and File Exchange

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!