Amesim-Matlab interface

Hi, i am setting up a script for amesim batch runs in matlab using the amerunbatch command. The run finishes smoothly. I get the message 'Simulations completed'. But i don't know how to extract the results for each case. For example i am setting a batch for engine rpmand i want the injected flow rate data for each run to plot. Thanks in advance. here is the example:

number = input('how many sets?\n');
btch = struct('type','set','param',struct('type',input('give the parameter type','s'),'name',input('give the parameter name','s'),'set',[]));
for i=1:number
    btch.param.set{1,i}=input('Give the parameter value','s');
end
ameputbatch('PA6_2014_08_19_myFluidLaxWendT20_v2_3_FMED',btch);
amepreparebatchrun('PA6_2014_08_19_myFluidLaxWendT20_v2_3_FMED');
amerunbatch('PA6_2014_08_19_myFluidLaxWendT20_v2_3_FMED');

[Guillaume]

You will probably more help on an Amesim forum, e.g. https://community.plm.automation.siemens.com/t5/System-Simulation-Simcenter-Amesim-Forum/bd-p/Simcenter_1D_forum

I'm not sure any of the helpers here are familiar enough with Amesim (I've never used its matlab interface).

[Yuvraj Singh Grewal]

Thank you Guillaume. Your response is much appreciated.