Double Bevel Gear Assembly Testrig

This example models three shafts connected at an arbitrary angle by three gears. The necessary blocks for a bevel gear assembly are contained in a masked subsystem with the key parameters exposed in a dialog box.



Bevel Gear 2x Assembly Subsystem

Open Subsystem

Bevel Gear 2x Assembly Constraints Subsystem

The Bevel Gear Constraint requires that the rest of the mechanism hold the two frames to which it is connected in alignment. This subsystem has the necessary constraints and parameterized Rigid Transform to hold the frames in the right position and orientation.

Open Subsystem

Simulation Results from Simscape Logging

The plot below shows the speeds of the three shafts connected by the double bevel gear assembly.