Answered
MATLAB System block 'SCRReferenceApplication/Simulation 3D Vehicle with Ground Following/Simulation 3D Vehicle' error occurred when invoking 'stepImpl' method of 'Simulation3D
This error appears because the vehicle is initialized outside the scene limits. It appears that you are not initializing the ini...

2 years ago | 1

| accepted

Answered
power system control in simulink
This error is due to changes in the behavior of masks since this model was created in MATLAB R2009b. Please right click on t...

3 years ago | 0

Answered
Texas Instruments C2000 Processor, error: gmake: *** No rule to make target `all'. Stop.
Hi Yun, This is an error message that is thrown by the "make" (make/gmake) command. One cause for this error message could be t...

3 years ago | 2

Answered
Unable to extract simulink block paths in my model
On line 6, it should be 'SubSystem' instead of 'Subsystem'. Instead of using 'strcmp', consider using 'strcmpi' to prevent the c...

3 years ago | 0

| accepted

Answered
Warning: The value of enumeration member 'VT_OK' differs from when the enumeration was saved. 'VT_OK' will be loaded with the new value.
These warnings can be resolved as follows: 1) Find the Simulink.Parameter objects or other data objects in the data dictionary ...

3 years ago | 0

| accepted

Answered
Lane preview with Scenario Reader
Hi Andrea, the Scenario Reader produces information about lane detection as you have mentioned. In the Scenario Reader Block, it...

3 years ago | 1