Configure Holding registers

Configure the starting address and the number of holding registers

Since R2024b

Model Configuration Pane: Hardware Implementation / Simulink or Embedded Coder Hardware Support Package / Hardware board settings / Target hardware resources / Modbus

Description

Select the Configure Holding registers parameter to configure the starting address and the number of holding registers.

Dependencies

To enable this parameter, set Mode to server.

Settings

on | off

Select this parameter to configure the starting address and the number of holding registers.

Holding Register Parameters

Parameter	Description	Default Value
Start address	Starting address of the holding register Dependencies: To enable this parameter, select Configure Holding registers.	0
Quantity	Number of holding registers Dependencies: To enable this parameter, select Configure Holding registers.	1

Recommended Settings

No recommendation.

Programmatic Use

No programmatic use is available.

Version History

Introduced in R2024b