Single ended mode offset calibration factor

ADC single ended offset calibration factor

Model Configuration Pane: Hardware Implementation / Simulink or Embedded Coder Hardware Support Package / Hardware board settings / Target hardware resources / ADC1, ADC2 and ADC3

Description

Specify the ADC single ended offset calibration factor.

This parameter is available only if Calibration mode is set to Specify calibration register manually and ADC conversion mode is either single ended or both single ended or differential.

This parameter is available only for STM32G4xx and STM32H7xx based boards

Settings

0

Specify the ADC single ended offset calibration factor.

This parameter is available only if Calibration mode is set to Specify calibration register manually and ADC conversion mode is either single ended or both single ended or differential.

This parameter is available only for STM32G4xx and STM32H7xx based boards

Recommended Settings

No recommendation.

Programmatic Use

No programmatic use is available.

Version History

Introduced in R2014b