Check usage of fixed-point data type with non-zero bias

Check ID: mathworks.jmaab.jc_0643

Guideline: jc_0643: Fixed-point setting

Identifies blocks with fixed-point output signal data type and non-zero bias.

For blocks that have a fixed-point data type for their output signals, check that block parameter Bias is set to 0.

This check requires a Simulink^® Check™ license.

This check does not include sub-checks because the MAB modeling guideline provides only one sub ID.

For reference, the MAB guideline sub ID(s) that are recommended for use by the NA-MAAB and JMAAB modeling standards organizations are:

Condition	Recommended Action
In the Data Type Assistant, Mode is set to `Fixed Point` but the value for Bias is not `0`.	Change the block parameter Bias to `0`.

Does not run on library models.
Supports exclusions.
Analyzes content of library-linked blocks. By default, the input parameter Follow links is set to on.
Analyzes content in masked subsystems. By default, the input parameter Look under masks is set to graphical.