Main Content

Two-Pulse Gate Multiplexer

Multiplex gate input signals to two quadrant chopper

expand all in page
  • Two-Pulse Gate Multiplexer block

Libraries:
Simscape / Electrical / Semiconductors & Converters / Converters

Description

The Two-Pulse Gate Multiplexer block multiplexes two separate voltage signals into a single vector. The vectorized signal can control the gates of two switching devices in a converter, such as a Two-Quadrant Chopper block.

Model

This block can model a two-pulse gate multiplexer through either physical signal ports or electrical ports:

  • PS ports — Two-pulse gate multiplexer with physical signal ports. Set the Gate-control port parameter to PS to control switching device gates in a converter block using Simulink® gate-control voltage signals. To multiplex and connect Simulink signals to the gate-control inport of a converter block:

    1. Convert each voltage signal using a Simulink-PS Converter block.

    2. Multiplex the converted gate signals into a single vector using the multiplexer block.

    3. Connect the vector signal to the G port of the converter.

  • Electrical ports — Two-pulse gate multiplexer with electrical conserving ports. To control switching device gates in a converter block using Simscape™ Electrical™ Electronics and Mechatronics blocks, set the Gate-control port parameter to Electrical. The electrical ports include pairs of electrical connections. Each pair corresponds to the gate and cathode of a switching device in the connected converter block.

Examples

First and Second Quadrant Chopper Control

First and Second Quadrant Chopper Control

Control a two-quadrant chopper. The two-quadrant chopper operates in the first and second quadrants, allowing positive and negative output current. The Control subsystem implements a simple PI-based control algorithm for controlling the output current. The load of the system is considered constant throughout the simulation.

BLDC Speed Control

BLDC Speed Control

Control the rotor speed in a BLDC based electrical drive. An ideal torque source provides the load. The Control subsystem uses a PI-based cascade control structure with an outer speed control loop and an inner dc-link voltage control loop. The dc-link voltage is adjusted through a DC-DC buck converter. The BLDC is fed by a controlled three-phase inverter. The gate signals for the inverter are obtained from hall signals. The simulation uses speed steps. The Scopes subsystem contains scopes that allow you to see the simulation results.

Ports

Input

expand all

Physical signal port associated with the gate terminal of the first switching device in a connected converter block.

Dependencies

To enable this port, set Gate-control port to PS.

Data Types: double

Physical signal port associated with the gate terminal of the second switching device in a connected converter block.

Dependencies

To enable this port, set Gate-control port to PS.

Data Types: double

Conserving

expand all

Electrical conserving port associated with the gate terminal of the first switching device in a connected converter block.

Dependencies

To enable this port, set Gate-control port to Electrical.

Electrical conserving port associated with the A-phase for the high-side switching device.

Dependencies

To enable this port, set Gate-control port to Electrical.

Electrical conserving port associated with the gate terminal of the second switching device in a connected converter block.

Dependencies

To enable this port, set Gate-control port to Electrical.

Electrical conserving port associated with the DC negative connection for the low-side switching device.

Dependencies

To enable this port, set Gate-control port to Electrical.

Parameters

expand all

Whether to expose PS or electrical control ports.

Extended Capabilities

C/C++ Code Generation
Generate C and C++ code using Simulink® Coder™.

Version History

Introduced in R2018a

expand all

See Also

| | |

Topics