J1939 CAN Transport Layer
Transport J1939 messages via CAN
Vehicle Network Toolbox / J1939 Communication
The J1939 CAN Transport Layer block allows J1939 communication via a CAN bus. This block associates a user-defined J1939 network configuration with a connected CAN device. Use one block for each J1939 Network Configuration block in your model.
Other Supported Features
The J1939 communication blocks support the use of Simulink® Accelerator™ and Rapid Accelerator mode. Using this feature, you can speed up the execution of Simulink models. For more information on this feature, see the Simulink documentation.
The J1939 communication blocks also support code generation with limited deployment capabilities. Code generation requires the Microsoft® C++ compiler.
Config name — J1939 network configuration name
configuration list option
The name of the J1939 Network Configuration block to associate this transport layer block with.
Device — CAN device
device list option
The CAN device, chosen from all connected CAN devices.
Bus speed — Speed of CAN bus
250000 (default) |
Speed of the CAN bus in bits per second, specified as one of the two rates supported by the J1939 protocol, 250000 or 500000. The default is 250000.
Sample time — Simulation refresh rate
0.01 (default) | numeric
Simulation refresh rate, specified as the sampling time of the block during
simulation. This value defines the frequency at which the J1939 CAN Transport Layer
block runs during simulation. For information about simulation sample timing, see, Timing in Hardware Interface Models. If the block is inside a
triggered subsystem or inherits a sample time, specify a value of
You can also specify a MATLAB® variable for sample time. The default value is
Introduced in R2015b