??? In an assignment A(I) = B, the number of elements in B and I must be the same.
2 views (last 30 days)
Show older comments
I have to write a program for school that can read the temperture in a rooftile dryingroom. A NTC will be connected to a data-acquiring card. but when I want to use formulas on the whole matrix this creates is gives the before stated error. Below is the relevant code (the last 2 lines produce the error):
...
s=daq.createSession('ni');
s.addAnalogInputChannel('dev1',0,'Voltage');
s.Rate=rate;
s.DurationInSeconds=tijdseenheid;
[data,time]=s.startForeground;
...
const_a=input('The value of consistant A: ');
const_b=input('The value of consistant B: ');
weerstand=input('The value of the resistor: ');
ubron=input('The value of the powersupply: ');
data(:)=((ubron-data)*weerstand)/data;
data(:)=const_b/log((data)/const_a);
...
1 Comment
Jan
on 12 Mar 2012
The error cannot be produced by two lines. Only one command can cause the error - afterwards Matlab stops.
Answers (1)
Tom
on 12 Mar 2012
I'm not entirely sure what the variables are, but you may be meaning to do an element-by-element divide, not a matrix divide: in this case use ./ not / to divide.
2 Comments
Jan
on 12 Mar 2012
You definitely need the elementwise operators. If you've tried this already without success, post your trials here.
See Also
Categories
Find more on GigE Vision Hardware in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!