Main Content

configurePlutoRadio

Configure ADALM-PLUTO radio firmware

Add-On Required: This feature requires the Communications Toolbox Support Package for Analog Devices ADALM-Pluto Radio add-on.

Description

result = configurePlutoRadio(chipset) configures the ADALM-PLUTO radio to operate in the specified chipset mode. The radio must be connected to host computer USB port 0 to use this syntax.

example

result = configurePlutoRadio(chipset,id) configures the ADALM-PLUTO radio to operate in the specified chipset mode and radio identifier. The radio must be connected to computer running this command.

example

Examples

collapse all

Connect one ADALM-PLUTO radio to the host via a USB interface. Execute configurePlutoRadio with the input argument 'AD9364' to change radio configuration to operate over the wider bandwidth and higher sampling rate.

configurePlutoRadio('AD9364')
ans = 
  1 

Connect one ADALM-PLUTO radio to the host via a USB interface port 1. Execute configurePlutoRadio with the input arguments 'AD9364' and 'usb:1' to change radio configuration to operate over the wider bandwidth and higher sampling rate for the radio connected to USB port 1 of the host computer.

configurePlutoRadio('AD9364','usb:1')
ans = 
  1 

Input Arguments

collapse all

RF transceiver firmware configuration to be used by the PLUTO radio, specified as 'AD9363' or 'AD9364'. configurePlutoRadio configures the PLUTO radio to the specified firmware configuration.

RF TransceiverLO Tuning RangeBandwidth

AD9363 (factory default)

325 – 3800 MHz

20 MHz

AD9364

70 – 6000 MHz

56 MHz

Note

Analog Devices® qualifies the PLUTO radio over a tuning range of 325 MHz to 3.8 GHz. This support package enables you to use the PLUTO radio outside the qualified tuning range by configuring the radio to operate using the AD9364 firmware. To extend the frequency range, at the MATLAB® command prompt, enter configurePlutoRadio('AD9364').

USB port identifier, specified as a character vector indicating the host computer USB port the radio being configured is connected to.

Example: 'usb:1', indicates that the radio connected to host computer USB port 1 will be configured.

Data Types: char

Output Arguments

collapse all

Outcome of ADALM-PLUTO radio configuration, returned as 1 if successful or 0 if unsuccessful.

Version History

Introduced in R2017b

Go to top of page