zcbreak

Configure simulation debugging session to pause when nonsampled zero-crossing events occur

Syntax

zcbreak

Description

zcbreak sets or clears a breakpoint that pauses simulation when a nonsampled zero-crossing event occurs.

• If the breakpoint was not set, the command sets the breakpoint.

• If the breakpoint had been set, the command clears the breakpoint.

You can use this function in a simulation debugging session started:

• Interactively, using the Simulink^® Toolstrip

• Programmatically, using the sldebug function

• Programmatically, using the sim function with the 'debug' name-value argument

Note

This function is available only for simulation debugging sessions started programmatically and for interactive simulation debugging sessions while paused within a time step.

Tips

To start a simulation debugging session interactively, add one or more breakpoints to your model, and in the Breakpoints List, check that Pause within time step is selected. When the simulation pauses on a breakpoint, some of the programmatic debugging commands, such as the stop command, are available for use in the MATLAB^® Command Window.

Version History

Introduced before R2006a

R2024a: sldebug prompt in MATLAB Command Window indicates when simulation debugging session is paused within time step

When you start a simulation debugging session using the Simulink Editor, you can issue some programmatic simulation debugging commands, such as probe or stop, while the simulation is paused within a time step. The sldebug command prompt (sldebug>>) now replaces the MATLAB command prompt (>>) to indicate in the MATLAB Command Window when the simulation is paused within a time step. As in prior releases, you can issue both MATLAB commands and the supported simulation debugging commands at the sldebug command prompt.

For more information, see Simulink Debugging Programmatic Interface.