Sets of measured data are often collected at various times and under different initial conditions. When you estimate model parameters using one data set and subsequently run another estimation with a second data set, your parameter values may not match.
You can use the Parameter Estimator to estimate the initial conditions using procedures that are similar to those you use to estimate parameters. You can then use these initial condition estimates as a basis for estimating parameters for your Simulink® model.
After you select parameters for estimation, as described in Specify Parameters for Estimation, you can specify initial conditions
of states in your model. By default, the estimation uses initial conditions
specified in the Simulink model. If you want to specify initial conditions other than the
defaults, use the Initial States panel in the experiment editor
dialog. For this example, right click
NewData and select
Edit... from the list to open the experiment editor. Then,
click Select Initial States button.
The Select Model States dialog for the
engine_idle_speed model looks like
Click the check box next to the state you would like to modify. For example, if
you select engine_idle_speed/Transfer Fcn and enter the initial
0, the Initial
States panel now looks like
Click Select Parameters in the Parameter Estimation tab. After you also select the parameters as described in Specify Parameters for Estimation, the Edit: Estimated Parameters dialog looks like the following figure.