Problem vertically aligning data in a table using fprintf
5 views (last 30 days)
Show older comments
I'm putting my meshgrid to a table and I'm trying to make it look more presentable. I can't seem to figure out how to get them to line up vertically. My current code is:
for i=1:11
fprintf('%2d %3.2f %3.2f %3.2f\n', t(i),X(i),X(i+11),X(i+22))
end
2 Comments
Accepted Answer
Walter Roberson
on 2 Oct 2011
Do not put any spaces in your format. Instead, increase the "3" in your "%3.2f" to indicate the total number of characters to the right that you want the right edge of that column to be over by. For example, with %15.2f the right-hand side of the numbers would be the 15th character to the right of the previous column.
(Note: more characters will be used if required by the data value, such as if you were to try to print 1E42 with a 15-character fixed-point format.)
More Answers (1)
Image Analyst
on 2 Oct 2011
Check your fonts: File/Preferences/Fonts. Maybe you're using a proportional font when you need a monospaced font.
See Also
Categories
Find more on Structures in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!