Error while using lsqnonlin
28 views (last 30 days)
Show older comments
I am using the Matlab function lsqnonlin for estimating a vector of several values. Before calling lsqnonlin, I am making a rough estimation of the 4 parameters, and afterwards the lsqnonlin is being initialized using these four parameters. The following error stops the execution:
Error using snls (line 48)
Objective function is returning undefined values at initial point. lsqnonlin cannot continue.
Error in lsqncommon (line 150)
[xC,FVAL,LAMBDA,JACOB,EXITFLAG,OUTPUT,msgData]=...
Error in lsqnonlin (line 237)
[xCurrent,Resnorm,FVAL,EXITFLAG,OUTPUT,LAMBDA,JACOB] = ...
Error in Untitled_2015 (line 53)
[x,resnorm,residual,exitflag,output,lambda,J]=lsqnonlin('myfunscwarz',thetan);
Looking forward for your suggestions !!
0 Comments
Answers (1)
Matt J
on 11 Oct 2015
Edited: Matt J
on 11 Oct 2015
I suggest you check the value of your objective function ('myfunscwarz') at the initial point and see if the error message is accurate.
1 Comment
John D'Errico
on 11 Oct 2015
Edited: John D'Errico
on 11 Oct 2015
You say the initial values are "rough". But does your objective function even return a valid result at that point? This is a check you should make on any optimization, BEFORE you start it out.
Think of an optimizer as a poor soul that you place somewhere on the surface of the earth, then tasked with finding the deepest valley by walking downhill. If you place him in the middle of an active volcano, he may die before he ever starts searching. This is generally a bad idea. (At least give him scuba gear though, since it may get wet in that deep valley.)
See Also
Categories
Find more on Direct Search in Help Center and File Exchange
Products
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!