How can i change the output power of a wind turbine induction generator in simpowersystems, and how can I measure the output power?
1 view (last 30 days)
Show older comments
Hello I've been trying to change the output power of a wind turbine induction generator from its menu window (shown below), but I can't figure out the change in power in the scopes I can't understand the resulting signals after I changed the nominal power.
Appreciate your help
0 Comments
Answers (2)
Joel Van Sickel
on 17 Sep 2020
Hello Qais,
you will also need to increase the power delivered to the motor. This will show up in the simulation as increase voltage and current.
Regards,
Joel
0 Comments
Ibrahim Athamnah
on 3 Jan 2022
Hello Qais,
I have almost the same problem.
If you solve it, please send to me the solution. My email is:
2019979009@ses.yu.edu.jo
0 Comments
See Also
Categories
Find more on Wind Power in Help Center and File Exchange
Products
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!