code generation using simulink
3 views (last 30 days)
Show older comments
Hi, i am a university student. i am trying to generate a code for ccs4( for c2000 piccolo f28035 microcontroller). but whenever i try to generate , i get the following error "The left-hand side of a . operator must be a valid scope identifier".
i dont know what to do.kindly help.
regards, waqas
0 Comments
Answers (3)
Kaustubha Govind
on 7 Feb 2012
Support for CCS 4.0 was only recently added (I think it was R2011a). Also, you need to use the XMakefile configuration for CCS 4.0. If you are using a newer version of MATLAB, follow the steps on Tutorial: Using Makefiles with Code Composer Studio 4.x and see if that helps.
6 Comments
Siva Aduri
on 19 May 2012
i am also trying to interface piccolo micro controller and i have followed the steps given but still it is showing could not build
Please help because i have tried it so many times
Kaustubha Govind
on 21 May 2012
Siva: If you've already followed my advice to Waqas and still were not able to resolve the issue, you should probably contact MathWorks Tech Support.
Gurudev
on 10 Dec 2012
I also had a hard time getting Matlab and Simulink to work with CCS. There is one good video that helped me start. I found it a bit long but it has all the steps needed, from installation to generating code for a simple Simulink model: It works for CCSv3.3 which is older but has automatic download and run from Matlab
I hope it helps.
1 Comment
c.m.f.s.
on 28 Dec 2012
I also face the same problem.I am using CCSV3.3.What should I do now?
0 Comments
See Also
Products
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!