How to change a block parameter using SimState?
3 views (last 30 days)
Show older comments
Hello everybody.
I'm trying to simulate different types of faults in a Simulink electrical power system. Then, I'm using SimState to get the system steady-state and from this point I want to apply the faults and check the behavior.
Thus, I'm using the Three-Phase Fault block to apply the fault and I need to change the type of fault at this block after SimState is loaded but system consider that is an error. How can I fix it?
0 Comments
Answers (0)
See Also
Categories
Find more on Fault Simulation in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!