Using for loop for plotting from a timetable?

Attached is a sample of my data that I would like to plot. I would like to use for loop to automate plotting from the timetable directly. Below is my code, however, it seems there is some problem. any thoughts would be appreciated. I would also like to get a handle to enhance the plot further.

for ii=1:2
    plot(TT2.Date,TT2.(:,ii))
end

Answer 1

[Walter Roberson]

    plot(TT2.Date, TT2{:,ii})

... and remember the "hold on"

Answer 2

[Peter Perkins]

I imagine that

plot(TT2.Date,TT2{:,1:2})

would also work. And if there's only two variables in your timetable, that's equivalent to

plot(TT2.Date,TT2.Variables)

where "Variables" is the default name to use, but it's whatever TT2.Properties.DimensionNames{2} is set to.

[Hydro]

Thanks Peter. There are a number of variables (~10). It would be very inconvenient to plot them one by one, that's why I want to use the loop to automate the plotting.

[Peter Perkins]

You only think you want a loop. This

plot(TT2.Date,TT2{:,1:2})

plots them both at once, without a loop.