Simulink, 2-FSK bitrate on real SDR
7 views (last 30 days)
Show older comments
Hello,
I am trying to develop model of the real transceiver (at least part of functionality) for CC1200 chip.
Right now I am trying to check and compare TX parameters of the my model and real transceiver.
For the RX I use CC1200 Development Kit (http://www.ti.com/tool/CC1200DK#). For the transmitting I use my Simulink model and SDR bases on Zedboard and AD9364.
Transceiver and receiver use 2-FSK modulation, 100 kHz deviation and 100 kbps speed.
My main question is: how can I syncronize (how can I set up correctly) model settings for the getting data packet with these parameters from SDR Tx?
Because right now I have built correct preamble, sync word and data structure (payload and crc), but I cannot receive it. In my spectrum analyzer (it's real device, not Simulink) I see data on the correct central frequency. But deviation is wider then expect. Laso I think I have wrong bitrate. I have 3 places for the changing model's settings: solver's step in the "Model configuration parameters", Samples per symbol in the M-FSK block and Baseband sample rate in the "ZC706 and FMCOMMS2/3/4 Transmitter" block. But I can't figure out how to match them together to get the desired bit rate and deviation.
I would be very grateful if you help.
0 Comments
Answers (0)
See Also
Categories
Find more on Communications Toolbox in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!