Two Errors Happen When Running R2019a Instead of R2018a on ADI RF SOM Board
2 views (last 30 days)
I have run the tones project successfully in MATLAB R2018a. I try to run the same thing in R2019a. I replaced the ADI RF SOM ARM-FPGA TX/RX blocks with AD936x TX/RX blocks. While running the project, the following errors happens:
Error occurred while executing External Mode MEX-file 'ext_comm': ExtTargetPktPending() call failed while checking for target pkt
Error occurred while executing External Mode MEX-file 'ext_comm': ExtSetTargetPkt() call failed on CLOSE. Ensure target is still running
Below is the screen shot. Could you tell me how to change the settings such that it does not happen again?