MATLAB Answers

turn off yyaxis mode

50 views (last 30 days)
Hi,
i tried to solve my problem but could not find any solutions.
The problem: If i plot two data sets with two different y axes, the subsequent plots also have two y axes. Example:
x = 1:10;
y1 = x.^2;
y2 = x;
hold on
yyaxis left
plot(x,y1)
yyaxis right
plot(x,y2)
hold off
plot(x,y1)
I tried to insert the hold command on different positions but everytime the next plot isn't working as i want it to:
So my question is, how do i get a "normal" plot after yyaxis was used.
The answer is probably very easy, but I'm not very into MatLab yet, so sorry in advance for this question ._.
If the question was already asked and answered a link to that discussion would be helpful as well :)
~Jakob

Accepted Answer

Walter Roberson
Walter Roberson on 19 Mar 2021
You are using LiveScript, which has its own rules for deciding when to plot things or not.
Experiment with using
clf
at the point that you want to switch back to single axes.
  1 Comment
Jakob Seifert
Jakob Seifert on 19 Mar 2021
yes it did work, thank you :)

Sign in to comment.

More Answers (1)

Achilleas Vortselas
Achilleas Vortselas on 19 Mar 2021
Instead of clf, you can also use:
cla(gca,'reset')
The benefit of that is if the axis is inside a GUI and not a Matlab figure, or if the figure has additional children aside from the axis.
  2 Comments
Achilleas Vortselas
Achilleas Vortselas on 20 Mar 2021
That's why reset is there. The documentation says so (at the very bottom of the page).
Also, I have been using it and it works.

Sign in to comment.

Products


Release

R2020b

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!