Jeremy Schaeffer

Last seen: 1 month ago | Active since 2022

Followers: 0 Following: 0

Statistics

Feeds

Question

Need help - no motion using prismatic joint with pulley system
I have a simple telescoping tube model, where the linear motion is controlled by a pulley system. The drive pulley is powered u...

2 months ago | 0 answers | 0

0

answers

Question

Multibody Error - Model not assembled - position violation
I have a multipbody model that involves an actuator moving linearly along a track (grey part in picture below). There are linka...

2 months ago | 0 answers | 0

0

answers

Question

Use Multibody Spool component with only pulling force (can't push)
I have a Simscape Multibody model that uses a hydraulic winch to control the extension and retraction of a level arm. When exte...

6 months ago | 1 answer | 0

1

answer

Question

CAN BUS communication issue - ID number does not match setting
I am using a Kvaser USBcan Pro 1 device to communicate with a TI processor board. I am using the Vehicle Network Toolbox bloxks...

2 years ago | 1 answer | 0

1

answer

Question

How to turn off MAT-file logging - option is greyed out
I am trying to optimize some code to be deployed to a processor board for testing. Running Code Generation Advisor, it suggests...

2 years ago | 1 answer | 0

1

answer

Question

Trouble getting ADC to output signal with F280049C board
I want to use an ADC block to output a signal from a sensor interfacing a TI F280049C board, but I am having issues getting any ...

2 years ago | 1 answer | 0

1

answer

Question

How to setup SD Card Logging for C2000 target
I am working with a TI F280049C Launchpad and trying to set it up for external SD Card logging. I'm trying this example (https:/...

3 years ago | 0 answers | 0

0

answers