Community Profile # Ayush Kumar Jaiswal

Last seen: 7 months ago Active since 2022

#### Statistics

• • #### Content Feed

View by

You are using different file name to retrieve contents. It should instead be: tau = ncread('Marconi_v02_map_5years.nc','mesh2d_...

7 months ago | 0

Is it possible to program the mouse cursor selection box on figures in MATLAB?
I think here is what you need: function dragpoints(xData,yData,xLower,xUpper,yLower,yUpper) figure; x = xData; y = yData; ...

7 months ago | 1

I have trained my neural network now I want to test it .I have left some some data only for testing it is not used in train .how I could test my model using untrained data
You can use yfit = predict(Mdl,X); Where Mdl is your trained neural network, and X will be your test datasets. See an exampl...

8 months ago | 0

| accepted

I have 3 SST plots which I wish to put side-by-side in 1 figure in the form of a 1x3 panel. How do I go about this? I have attached my plots and the code.
You may use following command to place different plots in a single figure at custom location: % in your case, m = 1, n = 3 % ...

8 months ago | 0

How to build this circuit sinusoidal state at Matlab simulink and run it? I got problem to run it
You may refer to following documentation to build and run an electric circuit: https://in.mathworks.com/help/physmod/sps/powers...

8 months ago | 0

how can i convert from one value to multi values
You want to calculate that function at different values of alpha, it can done using arrayfun (func, arr); Read the documentat...

8 months ago | 1

Best practices for converting MATLAB code to fixed point
Here are the links to follow for best practice for converting MATLAB code into fixed point: https://in.mathworks.com/videos/bes...

8 months ago | 0

Floating point to Fixed point
To note the workflow for converting MATLAB function blocks into fixed point follow the documentation below: https://in.mathwork...

8 months ago | 0

what is floating point model

8 months ago | 0

To convert different subsystems into fixed point by using fixed point tool, you need to manually right click that particular sub...

8 months ago | 0