Community Profile

photo

Debadipto


Last seen: 16 days ago |  Active since 2022

Followers: 0   Following: 0

Statistics

  • Thankful Level 1
  • Knowledgeable Level 2
  • First Answer

View badges

Feeds

View by

Answered
Error in Co-Simulation Simulink FMU and STAR-CCM+
Hi @Marina, It seems like the issue you're encountering might stem from problems with network stability. Please make sure your ...

18 days ago | 0

Answered
Implementation of trained faster rcnn for object detection on Coral accelerator edge TPu coprocessor
Hi @ahmad, According to the official documentation of Coral, both custom and pre-existing model can be utilized only if they're...

18 days ago | 0

Answered
Updating build in ROS msgs for controller_manager_msgs with rosgenmsg fails in Matlab21b
Hi @Alice, The error you're encountering during the build process seems to be related to the C++ code generated by MATLAB from ...

22 days ago | 0

Answered
Running code inspector with a For Loop Iterator
It's difficult to tell exactly what's causing the Code Inspector to slow down by just looking at the model. Could you please che...

22 days ago | 0

Answered
Unable to use Simulink's acceleration mode
Hi @鹏政, The MATLAB answer linked below outlines several potential causes for the error you're facing: https://www.mathworks.co...

22 days ago | 0

Answered
DAC0 pin from Arduino DUE is not working becouse of 12 bits settings on SImulink
Hi @Daniel, After reviewing the code from the other post, it seems to me the DAC0 issue might stem from an incorrect configurat...

23 days ago | 0

Answered
NaN values in fitglm
Hello @Sanjana, The NaN values you're encountering could be due to a conflict where one function is being inadvertently masked ...

2 months ago | 0

Answered
where to find variables being set in Example model simrfV2_radar_system
Hello @Robbin, So there are two things that we need to understand here: "Object parameters" & "Workspace variables". In simple ...

2 months ago | 0

Answered
Raspberry Pi solver issue in Simulink
Hi @A.S, It is hard to tell the root cause of the issue without looking into the specific hardware and setup you're using. One ...

2 months ago | 0

Answered
How to use the LTE module in a ns-3 and Matlab co-simulation ?
Hi @lahlou, The issue here seems to be originating from the ns-3 software. Hence, it would be best if you post the query on the...

2 months ago | 0

Answered
Error in Generating Point Spread Function
Hi @Asser, Replicating the 1D MTF using repmat actually creates a 2D MTF with repeated values, which is not rotationally symmet...

2 months ago | 0

Answered
Fixed Wing Manual Control using RC Transmitter/Joystick
Hello @Hasan Khanzada, The issue you're describing with the throttle not responding and the error message about the throttle be...

2 months ago | 1

| accepted

Answered
How to deploy code to custom STM32 board via ST-Link JTAG?
Hello @Tanmay, I understand that you are getting the error 'No STM32 MCU connected' during the deployment. STM32CUBEMX is rel...

2 months ago | 0

Answered
How do I interface Torch X haptic device with Matlab/SIMULINK
Hi @Ahmad, I believe you are asking for ways to interface "TouchX" haptic device with MATLAB/Simulink. The following github re...

2 months ago | 0

Answered
Anybody can check my code to build mass matrix of 6 DOF manipulator, especially UR10?
Hi @재욱 임, The discrepancy in the values of massMatrix is most probably an expected difference. It arises from the fact that URD...

3 months ago | 0

Answered
How to efficiently pass and read parameters using the system identification toolbox?
Hi @soeren, It is hard to say for sure if the improvement in computational efficiency is due to an underlying memory issue with...

3 months ago | 0

Question


Convert a integer matrix to a red and blue colored matrix
I have the following matrix A = [-1 1 1; 1 -1 1; -1 -1 -1], I want to convert it to a colored matrix with cells corresponding to...

1 year ago | 1 answer | 0

1

answer

Answered
How to plot a geographical surface temperature heat map?
Hi Ashfaq, as per my understanding, you have three matrices namely Lat, Lon and Temp, and you want to create a heatmap from them...

2 years ago | 0

| accepted

Answered
Readtable to put text into columns from .CSV file
As per my understanding, you have a code snippet that converts contents in a .csv file into a .txt file. Since the .csv files ha...

2 years ago | 0

| accepted

Answered
How do I match corresponding rows of class labels to data
As per my understanding, you have two tables, table Data_to_match (838 by 400) and table GrpLabel_to_match (275 by 2). You want...

2 years ago | 0

| accepted

Answered
Minimize the infinity norm of a matrix equation
As per my understanding, you have three know matrices M, N and K, and an unknown matrix V. You want to minimize the infinity nor...

2 years ago | 0