photo

Hasmawati


Loughborough Univ

Active since 2013

Followers: 0   Following: 0

Message

Statistics

  • Thankful Level 3

View badges

Feeds

View by

Question


How to get signal from target computer to oscilloscope
Dear all, I am currently testing my xPC Target components connection to know if all of them are working properly. On my targe...

11 years ago | 0 answers | 0

0

answers

Question


TCP/IP communication problem
Hi all, Finally I manage to get the right boot display on my target computer. Shown below <</matlabcentral/answers/uploade...

11 years ago | 1 answer | 0

1

answer

Question


xPC target does not show the correct display on the target computer
Dear All, Today I finally manage to create the boot disk and try to boot the target computer. However, my target computer did...

11 years ago | 2 answers | 0

2

answers

Question


Need help on xPC target with I/O card
Dear All, I need to install I/O card (NI PCI-6229) on my target computer. My question is, do I need to access to the computer...

11 years ago | 1 answer | 0

1

answer

Question


Basic question regarding xPC target setup
Hi all, I have a few basic questions that I would like to ask regarding xPC target setup. Please pardon my stupidity but I am...

11 years ago | 1 answer | 0

1

answer

Question


xPC target in Matlab R2013a does not show "Host PC Root" when the command xpcexplr is run
Hi all, I am new to xPC target. I am in the process of setting up my host and target PC. I am using Matlab R2013a 64-bit ne...

11 years ago | 1 answer | 0

1

answer