photo

Rashmi Bharadwaja


Active since 2016

Followers: 0   Following: 0

Message

Master thesis student

Statistics

All
  • Thankful Level 3
  • First Answer
  • Scavenger Finisher
  • Solver

View badges

Feeds

View by

Question


If-Else inside Stateflow Chart
Hello all, I am using if-else conditions indside a stateflow chart. When I try to simulate the chart, I get model and coder err...

7 years ago | 2 answers | 0

2

answers

Question


Convert Simulink model to TargetLink model
Hello all, Does anyone know how to convert a Simulink model into a TargetLink model? I have a huge Simulink model and would l...

7 years ago | 1 answer | 1

1

answer

Question


Designing bus signals with same names but different buses
Hello all, I have a simulink block with two buses which have a signal with the same name. AB_c.x1, HJ_k.x1. I would l...

7 years ago | 2 answers | 0

2

answers

Question


Assigning values to signal stuctures inside a state
Hello all, I have a bus containing 4 signals. These signals should be assigned boolean values in each state of a stateflow ch...

7 years ago | 1 answer | 0

1

answer

Question


Display information about the model at each level
Hello all, I am trying to display Simulink model information at each level. I would like to print the models on paper just for ...

7 years ago | 2 answers | 0

2

answers

Question


Difference between 32-bit and 64-bit Matlab 2011b versions?
Hello all, Do any of you know the differences between Matlab-2011b 32-bit and 64-bit versions? Thanks in advance. Chee...

7 years ago | 2 answers | 0

2

answers

Question


Is there a way to store large number of transition conditions in a Simulink block?
Hello all, Could anybody suggest a way to store a large number of transition conditions in a Simulink block (or file)? I have...

7 years ago | 1 answer | 0

1

answer

Answered
Is it possible to get block handles instead of port handles in get_param?
Block handles can be obtained by using the parameter 'PortConnectivity'. blckHandles = get_param(gcbh,'PortConnectivity') r...

7 years ago | 0

Question


Is there a way to count the number of signal paths from each inport to each outport?
Hello all, I would like to know if there is a way to count the number of paths from inports to its corresponding outports? For...

8 years ago | 1 answer | 0

1

answer

Question


Access Summary report data of Simulink models
Hello everyone, I am a student and very new to Matlab/Simulink. I am running ModelAdvisor on a Simulink model to check for un...

8 years ago | 1 answer | 0

1

answer