How can i detect Voiced,Unvoiced and Silence speech signal using Matlab??
15 views (last 30 days)
Show older comments
Voiced/unvoiced/silence detector: take speech signal and label each short segment as voiced, unvoiced or silence.
0 Comments
Answers (1)
Gabriele Bunkheila
on 13 Dec 2021
Hi, I have just come across your question. I appreciate this may no longer be timely but I am adding a couple pointers in case they can help others.
For isolating or segmenting speech in low-noise recordings, the function detectSpeech should work just fine. This will return start and stop times of all signal regions where speech is detected, but no text "transcription" of the actual speech content.
Based on that info you then can label each section of your recording as voiced or unvoiced.
0 Comments
See Also
Categories
Find more on Simulation, Tuning, and Visualization in Help Center and File Exchange
Products
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!