MATLAB HARDWARE , EXTERNAL MODE

I am looking to implemet a model ( full bridge converter) after doing the simulation , i want to know how to implement it by using external mode by launch pad f29379d, what is the blocks should i use and how to implement the control to control the model in hardware side.

Note:- already set up the embedded c2000 and I have the blocks in the library that I should used in hardware implementation.

[SALAH alatai]

up

[SALAH alatai]

@MathWorks Support Team

[SALAH alatai]

@MathWorks Support Team

Answer 1

[Mukul Choudhury]

Hi,

Please refer to the following motor control and power examples that are shipped along with C2000 Microcontroller Blockset:

https://in.mathworks.com/help/ti-c2000/examples.html?category=motor-control-examples&exampleproduct=all&s_tid=CRUX_lftnav

https://in.mathworks.com/help/ti-c2000/examples.html?category=power-conversion&exampleproduct=all&s_tid=CRUX_lftnav

We use two model approach to communicate with hardware using serial communication.

Thanks,

Mukul