- Connect the battery pack to the Arduino board: Make sure the battery pack is compatible with your Arduino board and can provide enough power to run your application. Connect the positive (red) wire of the battery pack to the VIN pin on the Arduino board, and the negative (black) wire to the GND pin.
- Upload the compiled code to the Arduino board: Use the Arduino IDE or a similar tool to upload the compiled code generated by MATLAB and Simulink to the Arduino board. Make sure the board is connected to your computer via USB during the upload process.
- Disconnect the USB cord: Once the code has been uploaded to the board, disconnect the USB cord from the computer and the board.
- Power on the battery pack: Turn on the battery pack and verify that the board is receiving power from the pack. You may need to use a multimeter or similar tool to measure the voltage output of the pack and ensure it is within the range required by your board.
- Run the application: With the board powered by the battery pack, run your standalone application as you normally would. The board should execute the code and perform the desired function.
Arduino standalone program fails after disconnecting usb
4 views (last 30 days)
Show older comments
I followed these instructions:
The script runs on the arduino uno until I unplug the usb cord. I have a battery pack connected to the uno.
When I execute the complied code, I reference the location of the ide in the matlab support folders from installation:
C:\ProgramData\MATLAB\SupportPackages\R2022b\aIDE
How can I disconnect the usb cord and have the arduino be powered by the battery pack to run the script?
0 Comments
Answers (1)
Nikhilesh
on 7 Mar 2023
It looks like you have successfully generated a standalone application for your Arduino Uno board using MATLAB and Simulink, and now you want to run the application using a battery pack instead of relying on the USB cord for power. Here are some steps you can follow:
Note that the specific steps and details may vary depending on your hardware setup and the requirements of your application. It's always a good idea to consult the documentation and resources provided by the manufacturers of your hardware and software tools to ensure you are following best practices and achieving the desired results.
0 Comments
See Also
Categories
Find more on Simulink Supported Hardware in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!