Remove NaN values from a table
28 views (last 30 days)
Show older comments
Hi,
I have an 84 column table that has EMG, gyroscope, goniometer and analog signal data. It was all collected at different frequencies and there are NaN values for rows that were sampled at lowest rate so that they match the column with largest amount of actual data. I just want to remove these NaN values so that i have a new table with columns of varying length that have actual data, and thus no NaN values. So to just further clarify, lets assume column 1 is emg and has 1000 data points and 200 NaN values, column 2 is gyroscope data so that has 300 data points and 900 NaN values, column 3 is goniometer data that has 400 data points and 800 NaN values and finally column 4 has analog data that contains no NaN values and has 1200 actual data points.
I would like to just remove the NaN values from the table so that column 1 now has 1000 data points, column 2: 300 data points, column 3: 400 data points and column 4 still the original 1200 data points.
can someone please help me out with this?
Thank you in advance!
0 Comments
Answers (2)
Image Analyst
on 3 Apr 2023
All columns in a table must be the same number of rows. To have what you want, you'd have to break apart your table into 4 (or 84) separate tables (or double vectors).
2 Comments
Image Analyst
on 3 Apr 2023
Maybe, but yoiu keep forgetting to attach your data. I'll check back later for it.
Star Strider
on 3 Apr 2023
I would not remove the NaN values.
1 Comment
Peter Perkins
on 5 Apr 2023
Right, as SS says, you should thiknk about why you want to do this. Your life might be easier if you did not. Hard to tell though, you would need to say what happens to these data down the road.
See Also
Categories
Find more on Get Started with Control System Toolbox in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!