need help with the simmulink blocks
3 views (last 30 days)
Show older comments
Chukwuebuka
on 12 Apr 2023
Answered: Bhanu Prakash
on 12 Apr 2023
how do i generate this type of plot in simulink with the step block
0 Comments
Accepted Answer
Bhanu Prakash
on 12 Apr 2023
Hi Chukwuebuka,
As per my understanding, you want to re-create the waveform shown in the picture using simulink.
This can be achieved by using two "step" blocks. One block "Step" having "Step time" & "Final value" as 1 & 1 respectively and the second block "Step1" having "Step time" & "Final value" as 9 & -1 respectively.
Add these two blocks using an "Add" block. The resulting output is your required waveform.
Consider the block diragram shown below, for your reference:
You can refer to the documentation of "step" block, for more info:
Hope this answer helps you.
Thanks,
Bhanu Prakash.
0 Comments
More Answers (1)
Amit Dhakite
on 12 Apr 2023
Edited: Amit Dhakite
on 12 Apr 2023
Hi Chukwuebuka,
You can generate the required graph as shown by you in the attached image by using two step blocks and a switch block.
Configure the first step block to generate value 0, when x is in between 0 and 1. And after step time 1 units, give final value as 1. It will give output as follows:
Configure the second step block to generate value 1 till the time 9 units, and after that set final value as 0. It will give output as follows:
Finally, use switch block to get the values till 9 units of time from the step_1, and after that from step_2.
A working example of the above model is attached here for you reference.
For further information, kindly refer to the following links:
0 Comments
See Also
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!