How to open Scope in Simulink with Matlab command?

Hi everyone

I want to run the simulink with the matlab command "sim". I need to see the trend of a signal . So, I use a Scope.

I want to open the scope with a matlab command line. Is there any way to open the scope in simulink with matlab command, not manually?

Regards

Answer 1

[Azzi Abdelmalek]

open_system('YourSimulinkModelName/ScopeName')

[Mahdiyar]

thanks

[carlos vasquez]

i use this comand but, when i want to use the command set_param(gsc,'Simulationcommand','Stop'). i have this error. subsystem block does not have a parameter named 'Simulationcommand'. also i use the comand close_param for close all but i have the same error. this command works on guide of matlab?

help