Control System Designer app error
4 views (last 30 days)
Show older comments
I want to tune couple of gain in my simulink model. After I choose the relevant blocks to tune I want to see the nichols of the open loop so I used LoopTransfer opening.
But I dont get (in the response section in the app) the ss variable of the linearization. when I tried to add the LoopTransfer opening location manually I get the following error:
"The selection location is defined as parmenent opening in the architecture. Remove this opening to create a request to this location"
I dont get this error. I tried to delete the LoopTransfer opening in my model, but I still get this error.
In addition I have one more quastion:
when I need to choose the signal for the lineariztion openning, The app have 2 section to specify:
- "Specify the open-loop response at the following locations"
- " Compute open looop response with the following loops open"
I don't understand the diffrent between this two. where do I need to specify the LoopTransfer opening for the linearization? when I will want to use both of this sections?
Thank you!
0 Comments
Answers (0)
See Also
Categories
Find more on Classical Control Design in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!