Hardware support for MATLAB Communication Toolbox

Hello,

I am using ADRV9009 with Intel Arria10 SoC FPGA and want to use MATLAB on these hardware devices. I am trying to figure out on how to add new devices to the Communications Toolbox.

Thanks in advance for your assistance.

Regards,

Ronald Victor Basil

[Bharath Venkataraman]

Could you please clarify on what you mean by add new devices? Do you want to do FPGA in the Loop simulation, or target the devices using VHDL or Verilog code?

[Ronald Basil]

Thank you for your response!

I am trying to figure out which blocks to use to be able to communicate with the adrv9009 on Arria10 SoC SPGA. Yes, FPGA in the loop simulation.

For targetting the device using Verilog Code, would it be correct if I followed the link below? https://wiki.analog.com/resources/eval/user-guides/matlab_bsp#supported_boards

Regards

[YP]

FPGA in the Loop simulation doesn't support any kind of ADC/DAC.

I think you want blocks similar to these SDR tx/rx blocks as in

https://www.mathworks.com/help/supportpkg/xilinxzynqbasedradio/referencelist.html?type=block&s_tid=CRUX_topnav

However, we don't support SDR solution on Arria10 SoC with adrv9009.

[Ronald Basil]

Thank you for your response!

In that case, is it possible create custom blocks?

Sincerely

[fgao]

Hello Ronald,

SoC Blockset product can help you to create Simulink block for your custom HDL IP. You can check out this example and see if it fits your needs.

https://www.mathworks.com/help/supportpkg/xilinxsoc/ug/import-custom-hdl-ip-into-soc-blockset-design.html

Thanks,

Fei