CAN Explorer and I/O 602 Speedgoat module

How do I connect my speedgoat module I/O602 and read data bus on CAN Explorer?

I refresh all hardwares available and only MathWorks virtual are listed.

Answer 1

[Dimitri MANKOV]

Hi Gabriel,

In short, you will need to insert the CAN driver blocks corresponding to your IO602 module in your model. These driver blocks are part of the Speedgoat I/O Blockset, which can be downloaded from your Speedgoat Customer Portal account.

You will also find product examples showing you how to use the IO602 module in the Speedgoat documentation here.

I hope this is helpful!

Dimitri

[Gabriel]

Hi Dimitri,

thanks for your prompt reply. I have been able to use IO602 module drivers.

The point is that I would like to use CAN Explorer to view incoming messages from the ECU that I connect to my speedgoat machine, instead of create a new CAN visualization.

In the attached image I have my model running on my speedgoat machine and CAN Explorer does not find the hardware.

[Dimitri MANKOV]

Hi Gabriel,

Sorry, I must have misread your question and missed the "CAN Explorer" part of it. As far as I know, Simulink Real-Time is not compatible with CAN Explorer for the moment.

You can, however, log the CAN messages received by your Speedgoat target machine using the Simulation Data Inspector (SDI) or the File Log block after unpacking them.

Dimitri

[Gabriel]

Hi Dimitri,

Thank you for your attention and guidance.