Hi Community members,
I am a beginner in PID simulation.
I use ADC block to generate a voltage/digital number at Time Scope0. but it gives 0 values all the time. Why?
PID is tuned by Automatic generator and then I can get the results at Time Scope 4,5,6.
Vref is 2V which is compared with my ADC values through Adder/Subtractor. the result of Adder/Subtractor is shown in Time Scope3 .
The Problem is why do i get always 0 amplitude at Time Scope0? Is there any problem in ADC settings to run the simulation?
ADC settings are below there:
MATLAB2021b version
Please suggest to simulate this PID based ADC conversion and genrating ePWM signals.
Thanks
Kind Regards
Arsalan