Can we use control system toolbox apps on simscape components
3 views (last 30 days)
Show older comments
I have made a motor drive with inverter. Now to design a PI controller using control system toolbox apps I am facing issues. Kindly help.
1 Comment
Sam Chak
on 29 Oct 2023
@Gopal Krishnan, it is rather difficult. Perhaps you expect a general 'Yes' or 'No' answer. If we switch roles, then you'd probably understand. For example, assuming that you are an inverter expert, how would you help me if I told you that I'm facing only one specific technical issue in the motor design?
Answers (1)
Sabin
on 1 Nov 2023
A good starting point is the Tune Field-Oriented Controllers for a PMSM Using Closed-Loop PID Autotuner Block example in Simulink Control Design. This example shows how to tune a field-oriented controller for a PMSM-based electrical-traction drive (implemented in Simscape Electrical) in just one simulation using the Closed-Loop PID Autotuner block.
0 Comments
See Also
Categories
Find more on Permanent Magnet in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!