Embedded Coder for STM32F446RE about CAN communication

Hello Matlab Support Team,

I am currently using Simulink to implement CAN communication with an STM32-NucleoF446RE board, but I am facing some difficulties and would like to request support.

At the moment, I have connected an MCU-230 transceiver to a 500 kbit/s CAN bus, with the RX-TX lines of the transceiver connected to the STM32 board. I have also ensured that the baud rate is set correctly, but the problem of not receiving any values through CAN Receive persists.

Attached are some images showing parts of the code I have written and screenshots from STM32 IDE.

If there is any information you need, feel free to ask, and I will provide it. Also, if I have made any mistakes, please don't hesitate to contact me.

[Sumukh]

Can you provide the Simulink model being used here?

[Saurav Shandilya]

Please refer to CAN based example for STM32 Communication Using CAN or FDCAN Blocks for STMicroelectronics STM32 Processor Based Boards - MATLAB & Simulink - MathWorks India

[MINHO]

Thank you for helping me :) This problem is solved.

[Saurabh]

I am facing a similar issue. Can you please provide the solution to your problem? That would be really helpful, thanks in advance.