- https://www.mathworks.com/help/releases/R2023b/supportpkg/parrot/ug/generic-dongle-in-windows.html
- https://www.mathworks.com/help/releases/R2023b/supportpkg/parrot/ug/minidrone-not-found-by-bluetooth-scan.html
- https://www.mathworks.com/help/releases/R2023b/supportpkg/parrot/ug/minidrone-not-found-by-bluetooth-scan-1.html
Parrot Minidrone - Firmware update - HW Setup Error
2 views (last 30 days)
Show older comments
Hello all,
I'd like to update the Firmware on the Rolling Spider Parrot Minidrone. I'm following these steps:
In the step 6 the drone is successfully recognized. But when I click on Next - error occurs after few seconds:
So may I ask you, does anybody experienced this behavior and does anybody know how to proceed? Because it does not seem that Firmware is updated.
Thank you
0 Comments
Accepted Answer
Kautuk Raj
on 17 Sep 2024
It sounds like you are encountering an issue during the firmware update process for your Rolling Spider Parrot Minidrone.
From the error message, it can be gathered that the “minidrone not detected” part indicates that the Parrot Minidrone was not successfully connected to the system either using the Built-in Bluetooth Module or a Generic Bluetooth Dongle.
I recommend you retry the connection using the steps entailed on this documentation page: https://www.mathworks.com/help/releases/R2023b/supportpkg/parrot/ug/connect-to-hardware-over-bluetooth-windows-drivers.html
You may also refer to these pages to troubleshoot the connection settings:
I hope following the guides will help you successfully update the firmware on your drone.
More Answers (0)
See Also
Categories
Find more on MATLAB Support Package for Parrot Drones in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!